EDGE2iEDGE3i Manual for Replacing the Y-shaped Filter Screen of an Oil Cooler

[Customer Version]

1、 Press the machine tool emergency stop switch (any emergency stop switch on the machine tool panel or manual control box), as shown in the following figure:

2、 Use a 21 # open-ended wrench to loosen the top nut of the Y-shaped filter screen, remove the filter screen, install a new 20 mesh filter screen, and then tighten the filter screen nut

三、Reset the emergency stop switch, press the yellow [RESET] key to clear the alarm, and then perform the machine tool zero point return

Note: If there is oil leakage from the locking nut of the Y-shaped filter screen during use, please use a wrench again to lock the nut. If you have any questions, please contact me